The sliding sleeve is in the middle of the transmission shaft structure

So are cardan shafts and drive shafts the same kind of machinery? What are the differences between cardan shafts and drive shafts? Today, our editor will solve this problem for everyone. 

When the position changes, the two ends of the transmission shaft are respectively connected with the input shaft and the output shaft by a cross shaft universal joint.China CV AxleI believe that after reading the content shared by the editor above, you have a specific understanding of cardan shafts and drive shafts, and you already know the differences between cardan shafts and drive shafts. 

A single universal joint cannot make the instantaneous angular velocity of the output shaft and the shaft input shaft equal, so it is easy to cause vibration, which intensifies the damage of the mechanical parts. The sliding sleeve is in the middle of the transmission shaft structure, and one end of the shaft head is connected to the flange plate through the spline; In the rear drive shaft structure, the sliding sleeve and the axle fork cooperate with each other. 

Due to the limitation of the axial size of the universal joint shaft, the deviation angle is required to be relatively large. The universal joint near the transaxle is the universal joint on the inner side of the half shaft, and the universal joint near the axle is the universal joint on the outer side of the half shaft. If you have any questions or needs about machinery, you can contact us in time through the official website .